IPsec on FreeBSD
These instructions are for IPsec in transport mode not IPsec in tunnel mode. IPsec in tunnel mode requires a too tight coupling with the routing table for dynamic routing because the policies can only be specified based on source/destination address and protocol not based on interfaces.
Requirements
- Root access to both endpoints
- Static IPv4 addresses for both endpoints unless you want to write a small shell script as hook for raccon.
- At least one static IPv4 on at least one endpoint unless you hate yourself.
Kernel configuration
The FreeBSD GENERIC kernel lacks support for in-kernel IPsec processing. Add this two lines to your kernel config and (re-)build your own kernel. If you're new to FreeBSD check Chapters 15.9.1 and 9 of the FreeBSD handbook.
options IPSEC #IP security
device crypto